Any equipment of CNC automatic lathe is inseparable from maintenance during use, and the processing process of CNC automatic lathe is also the same. Generally speaking, the maintenance of CNC automatic lathe processing is very important, including daily inspection, weekly inspection, monthly inspection, quarterly inspection and semi-annual inspection. Only careful maintenance can guarantee the smooth progress of CNC automatic lathe processing.

1. Automatic maintenance instructions for CNC lathes

1. Daily inspection of CNC automatic lathe processing. The daily inspection is mainly based on the normal operation of the various systems of the CNC automatic lathe. Main items: hydraulic system, lubrication system, hydraulic system, lubrication system.

2. CNC automatic lathe processing and weekly inspection. Weekly inspection items include CNC automatic lathe parts, spindle lubrication system, etc., and remove iron filings on CNC automatic lathe parts and clean up foreign objects.

3. Check the processing conditions of CNC automatic lathes every month. Mainly check the power supply and air dryer. Under normal circumstances, the power supply voltage rating is 180v-220v, and the frequency is 50Hz. If there is any abnormality, it should be measured and adjusted. The air dryer should be disassembled once a month, then cleaned and assembled.

4. Quarterly inspection of CNC automatic lathe processing. Three months later, the inspection and maintenance of the CNC automatic lathe was carried out around the CNC automatic lathe, the hydraulic system and the spindle lubrication system, including the accuracy of the CNC automatic lathe, the hydraulic system and the lubrication system.

5. CNC automatic lathe processing inspection for half a year. After half a year, check the hydraulic system, spindle lubrication system and X axis of the CNC automatic lathe. If there are any problems, the oil should be replaced and cleaned.

2. CNC automatic lathe manufacturers suggest that after familiarizing with the maintenance of CNC automatic lathe processing, let us take a look at the common problems and solutions in CNC automatic lathe processing.

1. The processing pressure of the CNC automatic lathe is abnormal, mainly because the pressure is too high or too low. You can start cleaning according to the specified pressure setting value, replace the normal pressure gauge, and check each system in turn.

2. There are many reasons for oil pump injection in CNC automatic lathe processing, including low oil tank oil level, oil pump reversal, low speed, high oil viscosity, low oil temperature, filter blockage, excessive vacuum tubing volume, air intake, shaft and rotor Wear and tear, etc., can only be one-to-one correspondence, which is problematic and requires targeted treatment.